===== ISO/IEC 7816-10 Identification cards — Integrated circuit(s) cards with contacts — Part 10: Electronic signals and answer to reset for synchronous cards =====
[[dido:public:ra:xapend:xapend.b_stds:tech:iso:start| return to the ISO Standards ]]

<table>
<caption>Data sheet for [[dido:public:ra:xapend:xapend.a_glossary:i:identification|Identification]] cards — Integrated circuit(s) cards with contacts — Part 10: Electronic signals and answer to reset for synchronous cards</caption>
| Title                      | Identification cards — Integrated circuit(s) cards with contacts — Part 10: Electronic signals and answer to reset for synchronous cards |
| Acronym                    | |
| Version                    | 1999|
| Document Number            | 7816-10|
| Release Date               | 1999  |
| Reference                  | [[https://www.iso.org/obp/ui/#iso:std:iso-iec:7816:-10:ed-1:v2:en]] |
</table>

  : **Note**: The following is an excerpt from the official ISO catalog. It is provided here as a convenience and is not authoritative. Refer to the original document as the authoritative reference.

==== Scope ====
This part of ISO/IEC 7816 specifies the power, signal structures, and the structure for the answer to reset between an integrated circuit(s) card with synchronous transmission and an [[dido:public:ra:xapend:xapend.a_glossary:i:interface|interface]] device such as a terminal.

The specifications in [[dido:public:ra:xapend:xapend.b_stds:tech:iso:7816-3]] apply where appropriate unless otherwise stated here.

It also covers signal rates, operating conditions, and communication with the integrated circuit(s) card.

This part of ISO/IEC 7816 specifies two types of synchronous cards: type 1 and type 2.


/**=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
/* To add a discussion page to this page, comment out the line that says 
  ~~DISCUSSION:off~~
*/
~~DISCUSSION:on|Outstanding Issues~~
~~DISCUSSION:off~~