===== ISO/IEC 7816-02 Identification cards — Integrated circuit cards — Part 2: Cards with contacts — Dimensions and location of the contacts =====
[[dido:public:ra:xapend:xapend.b_stds:tech:iso:start| return to the ISO Standards ]]

<table>
<caption>Data sheet for [[dido:public:ra:xapend:xapend.a_glossary:i:identification|Identification]] cards — Integrated circuit cards — Part 2: Cards with contacts — Dimensions and location of the contacts</caption>
| Title                      | Identification cards — Integrated circuit cards — Part 2: Cards with contacts — Dimensions and location of the contacts |
| Acronym                    | |
| Version                    | 2007|
| Document Number            | 7816-2|
| Release Date               | 2007 |
| Reference                  | [[https://www.iso.org/obp/ui/#iso:std:iso-iec:7816:-2:ed-2:v1:en]] |
</table>

  : **Note**: The following is an excerpt from the official ISO catalog. It is provided here as a convenience and is not authoritative. Refer to the original document as the authoritative reference.

==== Scope ====

This part of ISO/IEC 7816 specifies the dimensions and locations for each of the contacts on an integrated circuit card of an ID-1 card type. It also provides information on the way to identify which standards define the use of the contacts.

This part of ISO/IEC 7816 is to be used in conjunction with [[dido:public:ra:xapend:xapend.b_stds:tech:iso:7816-1]].

/**=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
/* To add a discussion page to this page, comment out the line that says 
  ~~DISCUSSION:off~~
*/
~~DISCUSSION:on|Outstanding Issues~~
~~DISCUSSION:off~~