Sidebar
dido:public:ra:xapend:xapend.b_stds:tech:iso:7816-10
ISO/IEC 7816-10 Identification cards — Integrated circuit(s) cards with contacts — Part 10: Electronic signals and answer to reset for synchronous cards
Table 1: Data sheet for Identification cards — Integrated circuit(s) cards with contacts — Part 10: Electronic signals and answer to reset for synchronous cards
| Title | Identification cards — Integrated circuit(s) cards with contacts — Part 10: Electronic signals and answer to reset for synchronous cards |
| Acronym | |
| Version | 1999 |
| Document Number | 7816-10 |
| Release Date | 1999 |
| Reference | https://www.iso.org/obp/ui/#iso:std:iso-iec:7816:-10:ed-1:v2:en |
- Note: The following is an excerpt from the official ISO catalog. It is provided here as a convenience and is not authoritative. Refer to the original document as the authoritative reference.
Scope
This part of ISO/IEC 7816 specifies the power, signal structures, and the structure for the answer to reset between an integrated circuit(s) card with synchronous transmission and an interface device such as a terminal.
The specifications in ISO/IEC 7816-03 Identification cards — Integrated circuit cards — Part 3: Cards with contacts — Electrical interface and transmission protocols apply where appropriate unless otherwise stated here.
It also covers signal rates, operating conditions, and communication with the integrated circuit(s) card.
This part of ISO/IEC 7816 specifies two types of synchronous cards: type 1 and type 2.
dido/public/ra/xapend/xapend.b_stds/tech/iso/7816-10.txt · Last modified: 2021/08/06 17:23 by murphy
Translations of this page:
